Customer matched zone "peninsular"
View cart “Gsm Modem (SIM900A)” has been added to your cart.
-
-
-
RM40.00
- This board which operates at 433 MHz frequency range is a remote control relay board that can be used in various electronic and robotic boards, systems which requires remote control and again systems which can be operated remotely.
- Add to cart
-
-
-
RM15.00
- 4-CH RF remote control is used to turn ON / OFF four different devices independently. Any of the four outputs can be configured to work independently in either toggle or momentary mode.
- Add to cart
-
-
-
RM28.00
- HC‐05 module is an easy to use Bluetooth SPP (Serial Port Protocol) module,designed for transparent wireless serial connection setup.
- Add to cart
-
-
-
RM45.00
- This relay is based on ESP-01S WIFI module. It is designed for smart home, Internet of thing and other DIY project. With this smart relay, you will easy to DIY your smart switch to control any device by your phone anywhere. *Note: ESP8266 wifi module is not included
- Add to cart
-
-
-
RM20.00
- The ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol stack that can give any microcontroller access to your WiFi network. The ESP8266 is capable of either hosting an application or offloading all Wi-Fi networking functions from another application processor.
- Add to cart
-
-
-
RM60.00
- This low cost yet powerful GPS receiver is based on the famous and high end u-Blox Neo-6M GPS module. It comes with small battery for hot-start, and there is built-in EEPROM too.
- Add to cart
-
-
-
RM90.00
- SIM900A Modem is built with Dual Band GSM/GPRS based SIM900A modem from SIMCOM. It works on frequencies 900/ 1800 MHz. SIM900A can search these two bands automatically. The frequency bands can also be set by AT Commands. The baud rate is configurable from 1200-115200 through AT command.
- Add to cart
-
-
-
RM30.00
- An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines. The Module is based on ESP-12/ESP8266 WiFi Module by AI thinker. Module integrates 3.3V Regulator, GPIO, PWM, IIC, 1-Wire and ADC all in one board.
- Add to cart
-
-
-
RM38.00
- The NodeMCU D1 mini V2 is minimal ESP8266 wifi board. The D1 mini is a mini wifi board based on ESP-8266EX. More infos here: http://www.wemos.cc
- Add to cart
-
-
-
RM55.00
- ESP32 is a single 2.4 GHz Wi-Fi and Bluetooth combo chip designed with TSMC ultra-low-power 40 nm technology. It is designed to achieve the best power performance and RF performance, showing robustness, versatility, excellent features and reliability in a wide variety of applications and different power profiles.
- Add to cart
-
-
-
RM20.00
- The NodeMcu is an open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines. The Development Kit based on ESP8266, integates GPIO, PWM, IIC, 1-Wire and ADC all in one board.
- Add to cart
-
-
-
RM38.00
- NodeMCU is the fastest leading edge low cost technologies to WiFi enabled IoT. Modern high-level mature LUA based technology.
- Add to cart